Difference between revisions of "Sandcrete"
(→Strength and usage: superscripted 2s) |
m (1 revision) |
(No difference)
| |
Latest revision as of 09:20, 20 September 2010
Sandcrete is a yellow-white building material made from Portland cement and sand in a ratio of circa 1:8. It is similar but weaker than mortar, for which the ratio is circa 1:5.
Sandcrete is usually used as hollow rectangular blocks, often 45 cm wide, 15 cm thick, and 30 cm with hollows that run from top to bottom and occupy around one third of the volume of the block. The blocks can be joined together with mortar.
Strength and usage
The final compressive strength of sandcrete can be as high as 4.6 N/mm2, which is much less than concrete's 40 N/mm2. Sandcrete is unsuitable for load-bearing columns, and is mainly used for walls, or for foundations if no suitable alternative is available. As material for walls, its strength is less than that of fired clay bricks, but sandcrete is considerably cheaper.
Sandcrete is the main building material for walls of single-storey buildings (such as houses and schools) in countries such as Ghana and Nigeria. Measured strengths of commercially available sandcrete blocks in Nigeria was found to be between 0.5 and 1 N/mm2, which is well below the 3.5 N/mm2 that is legally required there. This may be due to the need of the manufacturers to keep the price low, and since the main cost-factor is the Portland cement, they reduce that, which results in a block that starts behaving more like loose sand.
There is current research in using organic ash to replace Portland cement, which is better than simply using less Portland cement.
Coarse aggregate
Addition of coarse aggregates has been tried, since this is a cheap way to increase compressive strength, but since the cement content of sandcrete is small, so is the amount of water that is added to the sand/cement mix to cure it. Adding more solid materials makes the mix much less fluid, making it difficult to cast into blocks.
