Alinco DJ-180
From Self-sufficiency
Revision as of 12:05, 18 September 2010 by Jontas (Talk | contribs) (Created page with '==Specification== {| !1) General |- |Frequency Coverage: |- |RX: || 137.000 ~ 173.995MHz (T, TM version) |- |TX: || 144.000 ~ 147.995MHz (T, TM version) |- |RX: || 137.000 ~ 173…')
Specification
| 1) General | ||
|---|---|---|
| Frequency Coverage: | ||
| RX: | 137.000 ~ 173.995MHz (T, TM version) | |
| TX: | 144.000 ~ 147.995MHz (T, TM version) | |
| RX: | 137.000 ~ 173.995MHz (TA, TB, TA2, TB2 version) | |
| TX: | 137.000 ~ 173.995MHz (TA, TB, TA2, TB2 version) | |
| RX/TX: | 144.000~145.995MHz(TS, TSA, TZ, E, EA, EB version) | |
| Frequency Resolution: | 5, 10, 12.5, 15, 20, 25kHz steps | |
| Memory Channels: | 10 Channels (standard) | |
| Antenna Impedance: | 50 ohm unbalanced | |
| Signal Type: | F3E(FM) | |
| Power Supply Requirement:DC 5.5V~13.8V (Rated 7.2V Ni-Cd) | ||
| Dimensions: | Approximately 132(H) x 58(W) x 33(D) mm | |
| Weight : | Approximately 350g | |
| 2) Transmitter | ||
| Output Power: | I 5.0W with Optional 12V Ni-Cd Battery | |
| 2.0W with Standard 7.2V Ni-Cd Battery | ||
| (144.000~147.995MHz) | ||
| (160.000~165.000MHz)... TA2, TB2 only | ||
| Modulation System: | Variable Reactance Frequency Modulation | |
| Max. Frequency Deviation: | +/ -5kHz | |
| Tone Frequency: | 67.0 to 250.3Hz -38 Subaudible Encoding Tones | |
| (E, EA, EB version: | option) | |
| DTMF Encoder: | (TZ, EB version: | option) |
| Tone Burst: | (E, EA, EB version only) | |
| 3) Receiver | ||
| Receiver System: | Double-Conversion Superheterodyne | |
| Intermediate Frequency.' 1st IF: | 21.4MHz | |
| 2nd IF: | 455kHz | |
| Sensitivity: | 12dB SINAD less than -10dBu | |
| (144.000~17.995MHz) | ||
| (160.000~165.000MHz)... TA2, TB2 only |
