AN/URM-25D Signal Generator

From Self-sufficiency
Jump to: navigation, search
URM-25 Signal Generator c. 1955
URM-25 Signal Generator c. 1955
Uses Aligning antique radio equipment
Manufacturer Various, commissioned by U.S. Military
Model 25D

The AN/URM-25 Signal Generator was a device used during the 1950s and 1960s by the U.S. Military to test electronic equipment.

History

The AN/URM-25 were part of a series of vacuum tube-based signal generators built for the U.S. Military during the Cold War-era.

Today they are collected and used by vintage amateur radio and antique radio enthusiasts who say they provide a reasonably high accuracy and stability for a low cost with build quality reflecting tough military construction standards.[1]

Specifications

RF (Radio Frequency) can be varied between 10 kHz and 50 MHz with modulation selectable at 400 and 1,000 Hz. RF level from .1 to 100,000 microvolts or 2 volts is available depending upon termination load. Output impedance is 50,500 ohms.

Carrier oscillation is performed by 6AH6 with an additional 6AH6 buffer stage followed by a 6AG7 output amplifier. Modulation oscillations at 400 and 1,000 Hz are provided by 5814A. URM-25x models also contain internal VTVM (vacuum tube voltmeter) and crystal calibration.

The carrier frequency can be set by interpolation using the graduated dial. Additionally, the URM-25's have a BNC jack for constant 200 mV output that can be connected to a frequency meter to eliminate guesswork. A sufficient warm-up period is required to ensure the best stability at higher frequencies.

The cabinet cover includes accessories such as an impedance adapter, fixed attenuator and antenna simulator. Additional accessory kit MK-288 includes adapters and more dummy loads.[2][3]

Nomenclature and Model Differences

The URM-25 units were released in several series from 25A through 25J and some can have substantial differences in both circuitry and configuration from previous models. It is common to find units having differing identification tags; i.e. front face tag may differ from the cabinet tag. Additionally, some units have additional minor circuitry that do not show up on the schematic. The "URM" code is broken down to indicate General Utility, Radio, and Maintenance and Test Assembly.

Overhauling

Some present day electronic hobbyists say the URM-25 series is a good cost-effective choice to use for tuning radio equipment but overhauling can be tricky and time-consuming. Many say that the model F is easier to work on than the model D which is in relatively plentiful supply.[1]

See also

References

  1. 1.0 1.1 http://www.r-390a.net/Pearls/URM-25.pdf R-390a.net, URM-25x discussions
  2. R.F. Signal Generator Set AN/URM-25D, by United States Dept. of the Army, Dept. of the Army, United States Air Force, United States, Air Force. Published by Departments of the Army and Air Force, 1993
  3. TM 11-6625-278-20P, DEPARTMENT OF THE ARMY TECHNICAL MANUAL ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND SPECIAL TOOL LISTS, SIGNAL GENERATOR SET AN/URM-25D

External links