Search results

• Multivibrator
  ...emitter junction is backward-biased, it does not impact on the exponential process (R2-C1 integrating network is unloaded). Simultaneously, C2 that is fully d ...Q2 begins conducting and this starts the avalanche-like positive feedback process as follows. Q2 collector voltage begins falling; this change transfers thro
  18 KB (2,829 words) - 18:11, 9 December 2011
• Arithmetic logic unit
  An ALU must process numbers using the same format as the rest of the digital circuit. The forma
  11 KB (1,517 words) - 18:11, 9 December 2011
• System on a chip
  ...y interesting systems are too complex to fit on just one chip built with a process optimized for just one of the system's tasks. Chips are verified for logical correctness before being sent to foundry. This process is called [[functional verification]] and it accounts for a significant por
  9 KB (1,162 words) - 14:47, 10 December 2011
• Logic optimization
  '''Logic optimization''', a part of [[logic synthesis]], is the process of finding an equivalent representation of the specified [[logic circuit]]
  3 KB (433 words) - 14:48, 10 December 2011
• Breadboard
  ...d]]. [[Integrated circuit]] designs are a more extreme version of the same process: since producing prototype silicon is costly, extensive software simulation
  14 KB (2,149 words) - 14:48, 10 December 2011
• Image impedance
  ''Z''_i 2 is found by a similar process, but it is simpler to work in terms of the reciprocal, that is image admitt
  7 KB (1,093 words) - 14:48, 10 December 2011
• FO4
  '''Fan-out of 4''' is a process independent delay metric used in digital [[CMOS]] technologies.
  3 KB (429 words) - 14:48, 10 December 2011
• Network synthesis filters
  ...put impedance of the filter (the driving point impedance) which then, by a process of [[continued fraction]] or [[partial fraction]] expansions results in the ...ls are carried out only once. The actual filter required is obtained by a process of scaling and transforming the prototype.<ref>Matthaei, p83</ref>
  11 KB (1,738 words) - 14:48, 10 December 2011
• Reliability (semiconductor)
  ...[logic simulation]]), [[timing analysis]], [[temperature]] derating, and [[process control]]. ...ften pre-, and post burn-in for a set of parameters that assure operation. Process and design weaknesses are identified by applying a set of stress tests in t
  6 KB (779 words) - 14:48, 10 December 2011
• Honeywell
  ...rt Butz]], in 1885 and subsequent innovations in [[electric motor]]s and [[process control]] by '''Minneapolis Heat Regulator Company''' tracing back to 1886. ...Digital Process Communications protocol for its smart transmitters used in process measurement. Since then, smart communication protocols have evolved into va
  28 KB (3,757 words) - 14:49, 10 December 2011
• Surface-mount technology
  ...pads with a stainless steel or nickel stencil using a [[screen printing]] process. It can also be applied by a jet-printing mechanism, similar to an [[inkje ...] is used then the parts must be soldered later using a [[wave soldering]] process.
  34 KB (5,009 words) - 14:49, 10 December 2011
• Passive analogue filter development
  ...nical Journal'', vol 2, July 1923, pp.1-29</ref> treated noise as a random process with a continuous bandwidth, an idea that was well ahead of its time, and t ...ired for network synthesis filters, often needing a mathematical iterative process. Image filters, in their simplest form, consist of a chain of repeated, ide
  60 KB (9,254 words) - 14:49, 10 December 2011
• Digital electronics
  ...nary digits to represent it. While this requires more digital circuits to process the signals, each digit is handled by the same kind of hardware. In an anal ...ble [[software radio]]s. Such base stations can be easily reprogrammed to process the signals used in new cellular standards.
  33 KB (4,939 words) - 14:49, 10 December 2011
• Mechanical filter
  ...the final frequency since the [[engineering tolerance|tolerances]] of the process could otherwise result in a frequency higher than the following fine trimmi ...cutting)|grinding]] of the main resonating surface of the resonator; this process has an accuracy of around {{nowrap|±800 [[Parts-per notation|ppm]]}}. Bet
  52 KB (7,784 words) - 14:49, 10 December 2011
• Phase-locked loop
  ...d then phase-aligns to the transitions in the data stream with a PLL. This process is referred to as [[clock recovery]]. In order for this scheme to work, the ...an drive the flip-flops which sample the data, there will be a finite, and process-, temperature-, and voltage-dependent delay between the detected clock edge
  37 KB (5,933 words) - 14:50, 10 December 2011
• Mm'-type filter
  ...ion of m-type filters. Rather, it is a double application of the m-derived process and for those filters the arbitrary parameters are usually designated ''m'' ...tion with image impedance <code>''Z''_iΠm</code>. The m-derived process can now be applied to this new section, but with a new parameter ''m''<nowi
  15 KB (2,296 words) - 14:50, 10 December 2011
• DO-254
  ...requirements capturing and tracking throughout the design and verification process. The following items of substantiation are required to be provided to the F 4. Planning Process
  6 KB (829 words) - 14:50, 10 December 2011
• Superheterodyne receiver
  ...] (IF) amplifer, and a demodulator plus additional circuitry to amplify or process the original audio signal (or other transmitted information).
  31 KB (4,651 words) - 14:50, 10 December 2011
• Channel length modulation
  ...oncept to the [[Early effect|Early Voltage]] for BJTs. For a [[65nm|65 nm process]], roughly V_E ≈ 4 V/μm.<ref name=Sansen/> (A more elaborate a
  7 KB (993 words) - 14:50, 10 December 2011
• Composite image filter
  ...an adjust. It is arrived at by double application of the ''m''-derivation process. Its chief advantage is that it rather better at matching in to resistive It is possible to continue the m-derivation process repeatedly and produce mm'm<nowiki>''</nowiki>-types and so on. However, th
  21 KB (3,213 words) - 14:50, 10 December 2011
• Moore's law
  * The invention of the complementary metal–oxide–semiconductor ([[CMOS]]) process by [[Frank Wanlass]] in 1963.<ref>Wanlass, F., “Low stand-by power comple ...p designs, and software has to be written in a [[multi-threaded]] or multi-process manner to take full advantage of the hardware. Many multi-threaded develop
  53 KB (7,743 words) - 14:51, 10 December 2011
• Network analysis (electrical circuits)
  ...a collection of interconnected components. '''Network analysis''' is the process of finding the voltages across, and the currents through, every component i ..., the result is a [[DC circuit]]. The analysis of a circuit refers to the process of solving for the voltages and currents present in the circuit. The solut
  34 KB (5,380 words) - 14:51, 10 December 2011
• Single-sideband modulation
  ...a normal [[Amplitude modulation|AM]] signal, no information is lost in the process. Since the final RF amplification is now concentrated in a single sideband
  17 KB (2,658 words) - 14:51, 10 December 2011
• CMOS
  ...a comeback with the advent of [[high-k]] dielectric materials in the CMOS process, as announced by IBM and Intel for the [[45 nanometer]] node and beyond.<re [[Image:CMOS_fabrication_process.svg|thumb|150px|Simplified process of fabrication of a CMOS inverter on p-type substrate in semiconductor micr
  22 KB (3,407 words) - 14:51, 10 December 2011
• Integrating ADC
  ...rator to go ''down''. The ''up'' and ''down'' more accurately refer to the process of adding charge to the integrator capacitor during the run-up phase and re
  30 KB (4,839 words) - 14:52, 10 December 2011
• Time-domain reflectometer
  ...isolate failing sites in the same. The latter is primarily limited to the process industry.
  17 KB (2,593 words) - 14:52, 10 December 2011
• Avro Anson
  ...pcd">''Flight'' 30 January 1936, pp. c–d.</ref> To forgo this laborious process, early aircraft would often perform short flights with the landing gear rem
  50 KB (7,231 words) - 21:55, 17 February 2018

View (previous 250 | next 250) (20 | 50 | 100 | 250 | 500)