Dynamic equilibrium

A dynamic equilibrium exists when a reversible reaction ceases to change its ratio of reactants/products, but substances move between the chemicals at an equal rate, meaning there is no net change. It is a particular example of a system in a steady state. In thermodynamics a closed system is in thermodynamic equilibrium when reactions occur at such rates that the composition of the mixture does not change with time. Reactions do in fact occur, sometimes vigorously, but to such an extent that changes in composition cannot be observed. Equilibrium constants can be expressed in terms of the rate constants for elementary reactions.

Examples

In a new bottle of cola the concentration of carbon dioxide in the liquid phase has a particular value. If half the liquid is poured out and the bottle is sealed, carbon dioxide will leave the liquid phase at an ever decreasing rate and the partial pressure of carbon dioxide in the gas phase will increase until equilibrium is reached. At that point a molecule of CO₂ may leave the liquid phase, but then another molecule of CO₂ will pass from the gas to the liquid. At equilibrium the rate of loss of CO₂ is equal to the rate of gain. In this case, the equilibrium concentration of CO₂ in the liquid is given by Henry's law, which states that the solubility of a gas in a liquid is directly proportional to the partial pressure of that gas above the liquid. This relationship is written as

<math> p = kc \,</math>

where k is a temperature-dependent constant, p is the partial pressure and c is the concentration of the dissolved gas in the liquid. Thus, the partial pressure of CO₂ in the gas has increased until Henry's law is obeyed. The concentration of carbon dioxide in the liquid has decreased and the drink has lost some of its fizz.

Henry's law may be derived by setting the chemical potentials of carbon dioxide in the two phases to be equal to each other. Equality of chemical potential defines chemical equilibrium. Other constants for dynamic equilibrium involving phase changes include partition coefficient and solubility product. Raoult's law defines the equilibrium vapor pressure of an ideal solution.

Dynamic equilibria can also exist in a homogeneous system. A simple example occurs with acid-base equilibria such as the "dissociation" of acetic acid, in aqueous solution.

CH₃CO₂H 15px CH₃CO₂^- + H⁺

At equilibrium the concentration quotient, K, the acid dissociation constant, is constant (subject to some conditions)

<math>K_c=\mathrm{\frac{[CH_3CO_2^-][H^+]}{[CH_3CO_2H]}}</math>

In this case, the forward reaction involves the liberation of some protons from acetic acid molecules and the backward reaction involves the formation of acetic acid molecules when an acetate ion accepts a proton. Equilibrium is attained when the sum of chemical potentials of the species on the left-hand side of the equilibrium expression is equal to the sum of chemical potentials of the species on the right-hand side. At the same time the rates of forward and backward reactions are equal to each other. Equilibria involving the formation of chemical complexes are also dynamic equilibria and concentrations are governed by the stability constants of complexes.

Dynamic equilibria can also occur in the gas phase as, for example, when nitrogen dioxide dimerizes.

2NO₂ 15px N₂O₄; <math>K_P=\mathrm{ \frac{P(N_2O_4)}{P(NO_2)^2} }</math>

In the gas phase, square brackets are not used as these indicate a concentration, instead a capitalised P is used to indicate partial pressure.

Relationship between equilibrium and rate constants

In a simple reaction such as the isomerization:

<math> A \rightleftharpoons B </math>

there are two reactions to consider, the forward reaction in which the species A is converted into B and the backward reaction in which B is converted into A. If both reactions are elementary reactions, then the rate of reaction is given by

<math>\frac{d[A]}{dt}=-k_f[A]_t+k_b[B]_t</math>

where k_f is the rate constant for the forward reaction and k_b is the rate constant for the backward reaction and the square brackets, [..] denote concentration. If only A is present at the beginning, time t=0, with a concentration [A]₀, the sum of the two concentrations, [A]_t and B_t, at time t, will be equal to [A]₀.

<math>\frac{d[A]}{dt}= -k_f[A]_t+k_b\left([A]_0-[A]_t\right) </math>

File:Dynamic equilibrium.png

% concentrations of species in isomerization reaction. k_f = 2 s^-1, k_r = 1 s^-1

The solution to this differential equation is

<math>[A]_t=\frac{k_b+k_fe^{-\left(k_f+k_b\right)t}}{k_f+k_b}[A]_0</math>

and is illustrated at the right. As time tends towards infinity, the concentrations [A]_t and [B]_t tend towards constant values. Putting t=∞ into the expression above,

<math>[A]_\infty =\frac{k_b}{k_f+k_b}[A]_0;[B]_\infty =\frac{k_f}{k_f+k_b}[A]_0 </math>

In practice, concentration changes will not be measurable after <math>t \gtrapprox \frac{10}{k_f+k_b}</math>. Since the concentrations do not change thereafter, they are, by definition, equilibrium concentrations. Now, the equilibrium constant for the reaction is defined as

<math>K=\frac{[B]_{eq}}{[A]_{eq}}</math>

It follows that the equilibrium constant is numerically equal to the quotient of the rate constants.

<math>K=\frac{\frac{k_f}{k_f+k_b}[A]_0 }{\frac{k_b}{k_f+k_b}[A]_0}=\frac{k_{f}}{k_{b}}</math>

In general they may be more than one forward reaction and more than one backward reaction. Atkins states that, for a general reaction, the overall equilibrium constant is related to the rate constants of the elementary reactions by

<math>K=\left(\frac{k_f}{k_b}\right)_1\times \left(\frac{k_f}{k_b}\right)_2\dots </math>

Dynamic equilibrium for triple science

See also

• Equilibrium chemistry
• Static equilibrium
• Chemical equilibrium
• Radiative equilibrium

References

ca:Equilibri dinàmic zh:動態平衡